JOLLY RANCHER LOLLY POPS

PHOTO SUBMITTED BY Liz Hurdle Hymel

Suckers made from jolly ranchers!

JOLLY RANCHER LOLLY POPS

you will need:

lollipop sticks
hard candies (I used Jolly Rancher hard candies)
baking tray
aluminum foil
parchment paper
optional: Ziploc bags, rolling pin, cutting board

step one: assemble your candy
If desired, you can crush hard candies by placing in a Ziploc bag and break up coarsely with a rolling pin on a cutting board. You can use crushed candies in whatever pattern you desire. I didn’t crush the candy. I simply used three different colors of whole Jolly Rancher hard candies in a row.

step two: bake your candy
Preheat oven to 275 degrees. Line a baking tray with aluminum foil, then lay a piece of parchment paper on top of the foil. Assemble candies as desired. Only put about 4 lollipops per tray (to leave room for sticks later) and arrange a few inches apart. Bake about 6 minutes or until candies melt to desired effect. Make sure to keep your eye on the pops! Don’t let them bake too long or they will be too thin and misshapen. Immediately proceed to step three.

step three: insert stick
As soon as you remove the lollipops from the oven, place stick on lolly at one end, rolling to coat stick with the melted candy. Let cool completely on tray, then carefully remove paper from back. Warning! Your lollies will likely not be perfect ovals or rectangles or whatever shape you hope to create. There will be imperfections, but that’s what makes them lovely lollies, no?

Lollipop review from Serena

Okay so I made these with the kids today.. very easy.. my only qualm or complaint is that the wax paper stuck to my lollies and I had to put water on them and scrape it off … I will try greasing slightly next time and see if that works better

200 degree oven

for my flower when it started to get a little soft I used a spoon to push down my center of the flower so they would all connect

take out before it gets too melted

take a stick and slowly turn till the candy is coated on the stick to HOLD the stick into the sucker when it hardens

let cool completely so they will harden good